[Go Back]

Recent research indicates that over 50% of injuries on logging jobs-some of them fatal-occur due to employees' falling from mobile equipment or log trucks. These injuries are often attributed to improper dismounting techniques and failure to use appropriate equipment handrails and steps. All of these injuries are preventable if employees use the appropriate features as they were intended.

Mounting mobile equipment and log trucks is not as much a problem as dismounting. For the most part, employees use the appropriate steps and handrails when mounting the machine or truck. When mounting mobile equipment and log trucks, employees readily use the three-point method to get on or in the machine or truck.

The three-point method is the use at all times of at least three contact points when mounting a machine. The basic principle is to face the machine, grab the hand rails or other stable balance point with two hands, place a foot on a step, pulling up with the use of both hands and one foot; or reach with one hand while grasping an approved hand hold with the other hand and firmly placing both feet on steps or ladders. The object is to have a combination of two hands and one foot or two feet and one hand always in contact with steps, handrails, or other stable surface.

Most injuries occur when dismounting. Employees tend to jump down from equipment rather than use the steps and handrails. The correct dismounting method must include exiting backward (facing the machine) and maintaining three-point contact until touching the ground.

To enhance the overall safety the following are some points that should be emphasized:

Injuries caused by falling from mobile equipment and log trucks can be prevented. These steps can be used to prevent fall injuries and keep costs down in association with mobile equipment and log trucks.